Macintosh SE - Unable to Insert Disk All the Way; Internal Floppy Drive Runs Continuously; Does Not Eject Disk

Troubleshooting Symptom Charts/Floppy Drive (Continued) - 9
Floppy Drive
(Continued)
Unable to insert disk
all the way
1 Insert opened paper clip into hole beside drive.
2 Switch off system power and hold mouse button down while
switching power back on (to complete eject cycle).
3 Replace floppy drive.
Internal floppy drive
runs continuously
1 Replace bad disk.
2 Replace floppy drive.
3 Replace logic board. Retain customer’s SIMMs.
4 Replace floppy drive data cable.
Does not eject disk 1 Insert opened paper clip into hole beside drive.
2 Switch off system and hold mouse button down while
switching system back on (to complete eject cycle).
3 Replace floppy drive.