Do you have a question about the Mackie SA1232 and is the answer not in the manual?
LF Driver Size | 12" |
---|---|
HF Amplifier Power | 300W |
Output Connectors | XLR |
Type | Active |
Frequency Response | 40Hz - 20kHz |
HF Driver Size | 1.4-inch |
Tweeter Size | 1.4-inch |
Input Connectors | XLR |
Power Output | 1200W (LF: 600W, MF: 300W, HF: 300W) |
MF Driver Size | 6.5-inch |
Covers reading, retaining, following instructions, power sources, and servicing guidelines.
Advice on avoiding water, moisture, heat, and ensuring proper ventilation.
Precautions regarding power cords, polarized plugs, and grounding.
Warning against rigging, flying, or pole-mounting the cabinet.
Information on the risks of high noise levels and the need for hearing protection.
Details on XLR input and loop-through connectors for signal routing.
Explanation of level control, power status, signal presence, and limit indicators.
Location and function of the power switch and AC power input.
Wiring standards for balanced XLR input and loop-out connectors.
Instructions on using the LOOP OUT jack to connect multiple SA1232 speakers.
Advice on positioning the speaker on floors/stages and horizontal array arrangements.
Recommendation to protect speakers from moisture, especially when outdoors.
Guidance on ensuring adequate voltage and amperage for safe operation.
Explanation of AC power demands and performance impact.
Importance of airflow and airspace for cooling built-in amplifiers.
How the thermal switch and LED indicate overheating and system response.
Guidance on confirming issues before contacting service and general warranty advice.
Steps to diagnose and resolve no power, no sound, poor performance, noise, and hum.
Instructions for obtaining factory service, including RA numbers and packaging.
Guidelines for cleaning cabinets and protecting speakers from moisture and extreme temperatures.
Details on frequency response, sensitivity, SPL, and crossover points.
Information on total power, high, mid, and low-frequency amplifier types and ratings.
Dimensions, weight, materials, finishes, and mounting method.