Need help?Do you have a question about the Mackie SA1532Z and is the answer not in the manual?
General| Max SPL | 132 dB |
|---|---|
| LF Driver Size | 15 inches |
| HF Driver Size | 1.4 inches |
| Output Connectors | XLR |
| Enclosure Material | Plywood |
| Width | 18.5 inches |
| Depth | 15.5 inches |
| Type | Active |
| Tweeter | Compression Driver |
| Input Connectors | XLR |
Female XLR connector for balanced line-level signal from a mixing console or other source.
Male XLR connector for daisy-chaining the signal to other SA1532z cabinets.
Controls overall signal level to built-in power amplifiers from -15 dB to +5 dB.
Green LED indicates the unit is powered on and ready.
Illuminates when a signal is detected at the main input connector.
Lights when the amplifier limiter is activated to prevent clipping.
Lights if amplifier overheats, muting the signal for cooling.
Switch to turn the SA1532z loudspeaker system on and off.
Connects the AC linecord to provide power to the amplifiers.
Standard wiring for Hot, Cold, and Shield pins in XLR connectors for balanced signals.
Uses the LOOP OUT jack for daisy-chaining multiple SA1532z speakers.
Advice on rigging restrictions, splay angles, and moisture protection.
Guidance on placement to optimize sound, avoid mud, and enhance intelligibility.
Ensuring adequate airspace for heatsink cooling and operation.
Ensuring proper voltage and amperage supply for optimal performance.
Diagnosing and resolving problems like no power, no sound, poor bass, noise, or hum.
Details on obtaining warranty or non-warranty repair services.
Guidelines for protecting speakers from moisture and extreme cold.
To Next Page
