Macnaught MX Series - DIN Compact Pulse Module Information

Page 13 of 32
SETUP FUNCTIONS AND VARIABLES
1
TOTAL
11 UNIT L - m³- kg - lb - GAL - USGAL - bbl - no unit
12 DECIMALS 0 - 1 - 2 - 3 (Ref: displayed value)
13 K-FACTOR 0.000010 – 9,999,999 (As per Flowmeter report)
14 DECIMALS K-FACTOR 0 – 6 (This seng depend upon seng 24)
2 FLOW RATE
21 UNIT mL - L - m³- mg - g - kg - ton - GAL - bbl - lb - cf - REV - no
unit - scf - Nm³ - NL – P
22 TIME UNIT sec - min - hour - day
23 DECIMALS 0 - 1 - 2 - 3 (Ref: displayed value)
24 K-FACTOR 0.000010 - 9,999,999 (As per Flowmeter report)
25 DECIMALS K-FACTOR 0 - 6 (This seng depend upon seng 24)
26 CALCULATION per 1 - 255 pulses
27 CUTT-OFF 0.1 - 999.9 seconds
3 DISPLAY
31 FUNCTION Total - Flowrate
32 BACKLIGHT (OPTIONAL) O - Green - Amber
33 BL. BRIGHTNESS 1 – 5
4 POWER MANAGEMENT
41 LCD UPDATE Fast - 1 sec - 3 sec - 15 sec - 30 sec - o
42 BATTERY MODE Operaonal – Shelf
5 FLOWMETER
51 SIGNAL REED_LP
6 OTHERS
61 TYPE / MODEL F012 (Don’t touch)
62 SOFTWARE VERSION MCN0121 (Don’t touch)
63 SERIAL NO. 123456 ((Don’t touch))
64 PASS CODE 0000 – 9999 (Change if required)
65 TAG NUMBER 0000000 – 9999999 (Don’t touch)
Intrinsically Safe ERX display (Flow Indicator/Totalizer) Type (Fx)
For Programming, press PROG/ENTER button for 7 seconds.
Press CLEAR button to access functions and Press SELECT button to reach sub-functions
Setting up a value in sub function, press PROG and get use of buttons CLEAR & SELECT to adjust a value
Once the desired value is adjusted, press PROG button to finalize it
Once all sub functions are set, press PROG button for 3 seconds to go back to operational mode