12 Configuration and Operation MacroAir AirLynk
© 2019 MacroAir Technologies Toll Free: 866 668-3247 Fax: 909 890-2313 www.macroairfans.com
Rev Date: 071519
A Quick Start Guide
PLC STARTUP
Basic navigation around the PLC display
1. Use the up , down , left , and right
arrows to navigate through the options on the screen.
2. Press OK to select the currently highlighted option
(takes you to another screen or allows you to edit the
selected value).
3. If the option is editable you will then be able to edit it using the up and down arrows. To
get to the next digit press the left or right arrows. When you are done editing, press OK
to set the value.
NOTE: The fans will be auto discovered each time the PLC is powered on. Setting the fans
through the web browser will ensure that the PLC knows there is a fan at that address.
Fan Setup (Optional)
1. Select “Fan Network Setup”.
2. Check each fan that is on the network (See Fig. 1 Fan Values Table) to ensure that the PLC
found all the fans.
3. Return to “Main Page 1” and select Fan Blade Settings.
4. Optional: Set blade sizes (diameter) for each fan on the network (can be done through
BACnet).
5. Run all fans to ensure fan functionality.
Fig. 1: Fan Values Table
To Next Page
Loading...