GB-9
SYSTEM SETUP
Touch on the top left position to enter source interface.
The unit will return to previous mode display screen if
any operation is not performed in 5 seconds.
Touch on SET button on the above pic..The user can
start the system setting.
1.SETUP
Touch on the SET button and the screen will display as
following:
2.Audio
Touch on the AUDIO button and
the screen will display as following
In FIG.1, the user can adjust the value of BASS,
TREBLE and SUB WOOFER by tapping on + / - on the
touch screen.
In AUDIO setting, the user can adjust the sound output
effect leftwards or rightwards by tapping ▶ ◀ button;
the sound output effect front wards or rearwards by
tapping ▲▼ button.
3.Video
Press on the VIDEO button and the screen will display
as following:
In this setting, the user can adjust the value of
CONTRAST, BRIGHTNESS AND COLOR by tapping on
the items at the left/right end of each value bar.
According to the specific condition, the user can adjust
the light effect on screen by tapping BRIGHT, NORMAL
and SOFT modes.
To Next Page
Loading...