NTWB1
Installation & User Manual
Rev 0.3
3 Operation
3.1 Operation
3.1.1 Initial Steps
1. Ensure all electrical connections have been made correctly.
2. Screw the antenna on to the antenna socket if not already installed.
3. Turn on the 12V supply to the NTWB1
4. Check that the LED indicators are flashing green and red. (If NMEA
data is available the orange LED will flash also).
3.1.2 Connecting a WiFi Device
1. Navigate to the WiFi settings on the device you wish to connect to
the NTWB1.
2. Look for the 'Madman xxxx' SSID (where xxxx is a mix of numbers and /or
letters) in the list of available WiFi networks. See left image of
Illustration 3 for iPhone example.
3. Select the Madman xxxx network and wait for your device to
establish a WiFi connection. No password is required. See right image
of Illustration 3 for iPhone example.
4. When your WiFi device has connected to the NTWB1 the red LED will stop
flashing and will remain off
3.1.3 Configuring Software
Refer to your app's or software's documentation for guidance on
configuration to establish a TCP or UDP connection.
Generally, the three things to be configured are the protocol (TCP or UDP),
the IP address of the source of the data (169.254.1.1) and the port
(55555).
9
To Next Page
Loading...
Need help?
General