Maeda MC285C-3 - Page 3

0-1
CONTENTS
Item
Page
OVERVIEW
1- 1
1. OUTSIDE DRAWING
1- 2
1.1. NON-ELECTRIC MOTOR MODEL
1- 2
1.2 ENGINE AND ELECTRIC MOTOR SPECIFICATIONS
1- 2
2. DIMENSIONAL DRAWING OF OUTRIGGER WIDTH
1- 3
3. PRINCIPAL SPECIFICATIONS LIST
1- 4
4. COMPONENT MASS LIST
1- 6
5. LUBRICATING OIL
1- 7
6. WORKING RADIUS/LIFTING HEIGHT
1- 8
7. RATED TOTAL LOAD CHART
1- 9
[1] RATED TOTAL LOAD CHART FOR 4-FALL WIRE ROPE
1- 9
[2] RATED TOTAL LOAD CHART FOR 2-FALL WIRE ROPE
1- 10
[3] RATED TOTAL LOAD CHART FOR 1-FALL WIRE ROPE
1- 11
STRUCTURE AND MAINTENANCE PROCEDURE
2- 1
1. ENGINE ASSEMBLY
2- 3
1.1 ENGINE (DOMESTIC / CE) MODEL “YANMAR2TNV70-NMBA”
2- 3
1.1.1 COMPONENTS OF ENGINE
2- 3
1.1.2 ENGINE MODEL
2- 3
1.1.3 ENGINE ACCESSORIES
2- 4
1.1.4 FUEL PIPING
2- 6
1.2 ENGINE (U.S.) MODEL “SHIBAURA TYPE E672L-F-6701”
2- 7
1.2.1 COMPONENTS OF ENGINE
2- 7
1.2.2 ENGINE MODEL
2- 8
1.2.3 ENGINE ACCESSORIES
2- 9
1.2.4 FUEL PIPING
2- 11
1.3 FUEL TANK ASSEMBLY
2- 12
1.4 FUEL SENDER
2- 13
2. POWER TRANSMISSION SCHEMATIC DIAGRAM
2- 14
2.1 HYDRAULIC SYSTEM DIAGRAM
2- 14
2.2 SLEWING SYSTEM
2- 15
2.2.1. OUTSIDE DRAWING
2- 15
2.2.2 TOLERANCE OF LOOSENESS HEIGHT OF SLEWING BEARING
2- 16
3. UNDERCARRIAGE AND FRAME
2- 17
3.1 TRACK FRAME
2- 17
3.2 FRONT IDLER
2- 18
3.3 GREASE CYLINDER
2- 18
3.4 CARRIER ROLLER (UPPER ROLLING WHEEL)
2- 19
3.5 TRACK ROLLER
2- 19
3.6 TANDEM ROLLER
2- 20
3.7 SPROCKET
2- 20
3.8 RUBBER TRACKS
2- 21