To Next Page
J
Judy WilsonSep 9, 2025
What to do if no air blows out of my Maeda Construction Equipment?
- HHeather WilliamsSep 9, 2025
If no air blows out, the problem might be a blown fuse. Replace the fuse.
What to do if no air blows out of my Maeda Construction Equipment?
If no air blows out, the problem might be a blown fuse. Replace the fuse.
Why is the travel speed, slewing speed, boom and hook block operation speed too slow on my Maeda CC1908S-1?
The travel speed, slewing speed, boom and hook block operation speed might be slow due to insufficient hydraulic oil. Replenish the hydraulic oil to the specified level.
What to do if the engine oil pressure warning is displayed while the engine is running on my Maeda Construction Equipment?
If the engine oil pressure warning is displayed while the engine is running, it could be due to insufficient or too much engine oil. Ensure the oil level is correct. Another possible cause is a clogged engine oil filter, which should be replaced.
What to do if my Maeda CC1908S-1 Construction Equipment engine stops during operation?
If the engine stops during operation, it might be due to clogging of the fuel prefilter and main filter, which requires you to replace the filter. Another potential cause is insufficient fuel, so refuel if needed.
What to do if the starter operates, but the engine does not start on my Maeda CC1908S-1?
If the starter operates but the engine doesn't start, it could be due to insufficient fuel, so refuel. Another cause might be air mixed in the fuel system, requiring you to bleed the air. Also, check for clogging in the fuel prefilter and main filter, and replace the filter if needed.
What to do if the engine water temperature warning is displayed while the engine is running on my Maeda CC1908S-1?
If the engine water temperature warning is displayed, it may be due to insufficient cooling water, so ensure the cooling water level is correct. Another possible cause is radiator fin clogging, which requires cleaning. Also, the accumulation of dirt and scale in the cooling system may be the reason, so wash the system.
What to do if I see the EH01 error code on my Maeda Construction Equipment?
The EH01 error code means the hydraulic oil temperature was above 95 °C continuously. Run the engine at idle for a while without shutting it down.
What does EV001 mean on my Maeda Construction Equipment?
The error code EV001 indicates that the power supply voltage was below 22 V or above 30 V continuously while the engine was running. Visually check the battery and measure the voltage. Replace or recharge the battery as necessary. If the problem is not resolved, no answer.
Why is the air flow weak in my Maeda CC1908S-1?
Weak air flow could be due to a clogged internal or external filter, so clean the filter.
What to do if the crane operation does not stop even when overloaded on my Maeda CC1908S-1?
If the crane operation doesn't stop even when overloaded, it could be due to a communication fault or controller fault, which requires inspection or replacement. It could also be caused by defective wiring, which needs inspection and repair.
General| Brand | Maeda |
|---|---|
| Model | CC1908S-1 |
| Category | Construction Equipment |
| Language | English |
