What to do if the hydraulic oil temperature is too high in my Maeda CC1908S-1 Construction Equipment?
If the hydraulic oil temperature is too high, there could be several causes. First, check if the hydraulic oil level is insufficient and replenish to the specified level. Also, inspect the fan belt for looseness and adjust or replace it if necessary. Finally, the oil cooler fin might be clogged, so clean it.
What to do if extension, hoisting, and lowering operations are not possible even though there is no overloading on my Maeda CC1908S-1?
If extension, hoisting, and lowering operations are not possible even without overloading, it could be due to defective wiring, which needs inspection and repair. Another possibility is a defective controller, which may need inspection or replacement.
Why is there abnormal noise from the pump (air suction) in my Maeda Construction Equipment?
Abnormal noise from the pump, specifically air suction, can be caused by a couple of things. First, check for insufficient hydraulic oil and replenish it to the correct level. Alternatively, the hydraulic oil tank strainer element might be clogged, requiring you to wash it.
How to fix detached crawler tracks on Maeda Construction Equipment?
If the crawler tracks detach, it's likely because they are too loose. Adjust the tension of the crawler tracks.
What to do if the engine water temperature warning is displayed while the engine is running on my Maeda CC1908S-1?
If the engine water temperature warning is displayed, it may be due to insufficient cooling water, so ensure the cooling water level is correct. Another possible cause is radiator fin clogging, which requires cleaning. Also, the accumulation of dirt and scale in the cooling system may be the reason, so wash the system.
What to do if the starter operates, but the engine does not start on my Maeda CC1908S-1?
If the starter operates but the engine doesn't start, it could be due to insufficient fuel, so refuel. Another cause might be air mixed in the fuel system, requiring you to bleed the air. Also, check for clogging in the fuel prefilter and main filter, and replace the filter if needed.
What to do if my Maeda CC1908S-1 Construction Equipment engine stops during operation?
If the engine stops during operation, it might be due to clogging of the fuel prefilter and main filter, which requires you to replace the filter. Another potential cause is insufficient fuel, so refuel if needed.
What to do if the engine oil pressure warning is displayed while the engine is running on my Maeda Construction Equipment?
If the engine oil pressure warning is displayed while the engine is running, it could be due to insufficient or too much engine oil. Ensure the oil level is correct. Another possible cause is a clogged engine oil filter, which should be replaced.
Why is the travel speed, slewing speed, boom and hook block operation speed too slow on my Maeda CC1908S-1?
The travel speed, slewing speed, boom and hook block operation speed might be slow due to insufficient hydraulic oil. Replenish the hydraulic oil to the specified level.
General| Brand | Maeda |
|---|---|
| Model | CC1908S-1 |
| Category | Construction Equipment |
| Language | English |
To Next Page
