How to troubleshoot a Mafell 971423 that cannot be switched on?
If your Mafell Saw won't turn on, the issue might stem from several causes. First, check that the power supply is working correctly. Next, inspect the mains fuse and replace it if it's defective. Lastly, worn carbon brushes could be the culprit, in which case you should take the machine to a MAFELL customer service shop.
What to do if Mafell Saw stops while cutting?
If your Mafell Saw stops during cutting, there are a couple of things to check. A mains failure could be the cause, so verify the mains back-up fuses. Alternatively, the machine might be overloaded; try reducing the feed speed.
Why does my Mafell 971423 leave burn marks on the cut surfaces?
If you notice burn marks on the cut surfaces when using your Mafell Saw, it may be due to an unsuitable or blunt saw blade. Try replacing the saw blade to resolve this issue.
How to fix a blocked chip outlet on a Mafell Saw?
A blocked chip outlet in your Mafell Saw can occur for several reasons. It may happen due to operation without extraction. Turn the machine off and remove the chips by opening the slider 39. Another reason could be extraction that is too weak; in this case, use an extraction unit that guarantees an air speed of at least 20 m/s at the extraction connection piece. Finally, wood particles in the chip ejector may be the cause. Open the slider 39 and remove the wood particles downwards out of the chip duct. If this is not completely possible, lower the saw blade as far as possible, then close the slider again.
What to do if workpiece clamps when feeding with Mafell 971423 Saw?
If the workpiece clamps when feeding your Mafell Saw, it could be due to a blunt saw blade. Immediately hold the workpiece, turn the motor off, and exchange the saw blade. Another potential cause is that the stop rail of the universal and/or of the multi-function stop is not parallel to the saw blade. Readjust the stop rail.
Why does Mafell 971423 switch off automatically during idling?
If your Mafell Saw switches off automatically during idling, it's likely due to a mains failure. Check the mains back-up fuses. Note that the machine won't restart on its own because of the installed under-voltage protection; you'll need to turn it on again after power is restored.
How to fix stiff height adjustment on Mafell 971423?
If the height adjustment on your Mafell Saw feels stiff, the threaded spindle, drive segment, and guide rod might be dirty. Clean these components and then grease or lubricate them.
Mandatory devices ensuring safe machine operation; must not be removed or disabled.
Defines correct usage and highlights inherent risks even when used properly.
Essential guidelines and precautions for safe operation and user protection.
Guidance on selecting the correct saw blade and procedures for replacement.
Details on using the machine as a pull-push saw or circular saw bench.
Selecting the appropriate blade speed for different materials.
Continuously adjusting the saw blade cutting depth.
General| Category | Saw |
|---|---|
| Type | Band Saw |
| Universal motor | Yes |
| Cutting height | 305 mm |
| Weight | 81 kg |
| Model | 971423 |
To Next Page
