MB190UC-BL / MB190UC-BK / MB190UC-OR / MB190UC-GR / MB190UC-NG / MB190UC-YE
3 Rev. 03/16/05
TROUBLESHOOTING
Troubleshooting Points during MB190UC Assembly.
Problem: Drawers appear not to fit, don’t slide in accurately
and bump the cart sides.
Solution: The roller bearing slides must be fully engaged into
the mounting slots on all drawers. They potentially could fall
out of position while turning the cart on its lid, back, or onto
its casters.
Remove the drawer that is out of position. The drawer is
removed by the two clips on the roller bearing slides.
Simply push the roller bearing slide back down into position.
Insert the drawer back onto the roller bearing slides
Problem: Back Lock/Unlock Switch does not engage
the drawer.
Solution: The inside Lock/Unlock slide potentially could fall
out of its groove while turning the cart on its lid, back, or onto
its casters.
Unscrew the four screws that are holding the Lock/Unlock slide
in place.
Once the screws are removed simply place the latch back onto
the slide and tighten the four screws back down.
HARDWARE SPECIFICATIONS
1a x 32 pcs.
1b x 8 pcs.
2 x 72 pcs.
3 x 56 pcs.
8 x 16 pcs.
MB190UC, -BK, -BL, -GR, -NG, -OR, -YE
3 Drawer Deluxe Utility Cart
SERVICE CART WEIGHT CAPACITY
Maximum Total Net Load . . . . . . . . . . . . . . .500 LBS
Top and Bottom Shelf
. . . . . . . . . . . . .150 LBS each
Drawers . . . . . . . . . . . . . . . . . . . . . . . . . .75 LBS each
Sliding Work Surface (closed)
. . . . . . . . . . .200 LBS
Sliding Work Surface (fully extended)
. . . . .50 LBS
PLEASE NOTE: Loading cart beyond rated
capacity may cause structural damage to the
cart as well as personal and /or property damage.
Please educate your customers to the dangers
of overloading.
To Next Page
Loading...
