MAG TOOLS MB199UC - Accessory Mounting; Attaching and Relocating Accessories

®
5
Instructions
UTILITY CARTS and ACCESSORIES
MB199UC / MB199UCFD UTILITY CARTS and ACCESSORIES - MANUAL - REV 1.0 - 2013
PN# 080106
Attaching and relocating accessories
The MB199UC utility cart platform accepts a variety of
specially designed accessories that attach via the corner rail
system. This system allows you to create a custom
Below is a small variety of accessories and instructions for
attachment and relocation:
A. Screwdriver holder, B. Utility bin shelf/screwdriver holder,
C. Aerosol can holder, D. Power tool holster, E. Large liquid
container shelf, F. Trash container holder, G. Cord wrap
NOTE: A larger family of accessories will be available using
the same attachment process.
1. Using the supplied wedge nut (I.) and the button
head fastener (H.) insert the fastener through the
most outboard mounting hole on the accessory you
wish to attach.
2. Thread a small portion of the wedge nut (I.) onto the
fastener (H.) NOTE: leave enough slack in the thread
to easily maneuver the assembly into place on the
carts corner rail slots.
3. Attach threaded nut assemblies (J.) to both sides of the
accessory before placing in the slot of the corner rails.
4. Once the threaded nuts are inserted in the slot on the
corner rails, lower into desired position and fully tighten
to prevent the accessory from moving in use.
NOTE: The accessory fasteners may need tightened periodically
to help prevent the accessories from moving.
A.
B.
C.
D.
G.
F.
E.
I.
H.
J.
MBUC-SDH
MBUC-SDPBH
MBUC-ACH
MBUC-PTH
MBUC-FCH
MBUC-TCH
MBUC-CW