Pedal Drive Assembly Instructions
Step 1:
Install the Splash Shield
Locate the splash shield mounting holes on the
drive shaft. There are 3 holes and 3 plugs on each
side.
The splash shield can be positioned in any of these
holes, we suggest mounting the splash shield to
the center holes.
Remove the protective plug from the center hole
on both sides of the drive shaft
Step 2:
Using the 4mm Allen Wrench, remove the
mounting screw from the splash shield.
Position the splash shield on the drive shaft
aligned with the center holes.
Insert the screw and tighten with the 4mm Allen
Wrench.
Page 17 of 29
To Next Page
Loading...