21
Unsatisfactory
Washing
The dishes are
not clean
Improper wash
program selected.
Select a more intensive program. Refer to “Wash Cycle
Table”.
Not enough detergent
was dispensed.
Use more detergent, or change your detergent.
Items are blocking the
path of spray arms.
Rearrange the items so that the spray arms can rotate freely.
The filter system
in the base of wash
cabinet is not clean or
is not correctly fitted.
This may cause the
spray arm jets to get
blocked.
Clean and/or fit the filter correctly. Clean the spray arm jets.
Refer to “Dishwasher Care” section.
Glassware is
cloudy
Combination of soft
water and too much
detergent.
Use less detergent if you have soft water and select a short
cycle to wash the glassware and to get it clean. See “Wash
Cycle Table”
Black or gray
marks on dishes
Aluminum utensils
have rubbed against
dishes.
Use a mild abrasive cleaner to eliminate the marks.
Detergent left in
dispenser cups
Dishes blocking deter-
gent cups.
Re-load the dishes properly. See the “Loading the Dish-
washer” section.
Unsatisfactory
Drying
The dishes are
not drying
Dishes not loaded
correctly.
Load the dishwasher as suggested in the directions.
Too little rinse aid.
Increase the amount of rinse aid or refill the rinse aid
dispenser.
Dishes removed too
soon.
DO NOT empty your dishwasher immediately after washing.
Open the door slightly so that the steam can escape. Begin
unloading the dishwasher only once the dishes are cool
enough to touch. Empty the low basket first. This prevents
water from dripping off dishes in the upper basket.
Wrong program
Selection.
Short wash cycles use lower temperatures which lessen
performance. Choose a longer wash program.
Using cutlery with a
low-quality coating.
Water drainage is more difficult with these items. Cutlery
or dishes of this type are not suitable for washing in the
dishwasher.
ERROR CODES
Codes Meanings Possible Causes
E1 Longer water inlet time
Faucet not fully open.
Water intake restricted.
Low water pressure.
E4 Overflow Dishwasher is leaking.
WARNING: If overflow error occurs, turn off the main water supply before calling for service. If there is water
in the base from an overflow or leak, the water should be removed before restarting the dishwasher.
To Next Page
Loading...
Need help?
General
