Magic-Pro Computer MP-6VIP-C+ - Peripheral Wake-Up Settings; Modem, LAN, and RTC Wake-Up

23
BIOS
An input signal on the serial Ring Indicator (RI) Line (in other
words, an incoming call on the modem) awakens the system
from a soft off state.
Modem Ring Resume
When On of VGA, any activity from one of the listed system
peripheral devices or IRQs wakes up the system.
Choice: On(default), Off.
VGA
When On of LPT&COM, any activity from one of the listed
system peripheral devices or IRQs wakes up the system.
Choice: LPT/COM(default), NONE, LPT or COM.
LPT & COM
When On of HDD&FDD, any activity from one of the listed
system peripheral devices wakes up the system.
Choice: On(default), Off.
HDD & FDD
When On, any activity from one of the listed system periph-
eral devices wakes up the system.
Choice: On, Off(default).
DMA / master
Wake On LAN
Enabled: Wake on the system from the LAN card (LAN card
must support wake on LAN function and the power
supply must provide at least 5V/7750mA standby
current)
Disabled(default): Disable Wake On LAN function.
When Enabled, you can set the date and time at the which
the RTC(Real Time Clock) alarm awakens the system from
suspend mode.
Choice: Disabled(default), Enabled.
RTC Alarm Rescume
Primary INTR
When set to On, any event occurring at will awaken a system
which has been powered down.
On(default): The system can not enter the power saving mode
when I/O ports or IRQ# is activated.
Off: The system still can enter the power saving mode when
I/O ports or IRQ# is activated.