62
2
nd
phase : rinsing
1. Rinse out the water tank thoroughly and fill it with fresh water
up to the “MAX.” level. The indicator light will go out.
2. Empty and replace the trays, the following lights will appear :
.
3. Rinsing the nozzle side :
- Place a fairly large container under the nozzle.
- Turn the Hot water/steam selector to , the following lights
will appear :
.
After a number of minutes :
.
- Empty the container. Remove and then replace the trays, the
following lights will appear :
.
The nozzle and the water may be scalding hot.
4. Rinsing the flow head side :
- Turn the selector back to 0 : .
After a number of minutes : .
NB : the water will flow directly into the drip tray.
- Empty and replace the trays, the following lights will appear :
= last rinse : press the button.
5. Clean the water tank, the drip tray and the grounds tray with a
non-abrasive washing-up liquid and then replace them.
The machine is now ready again :
.
NB : If , empty the tray and replace it.
To Next Page
Loading...
Need help?
General
