Magmate 180P - Electrical Shock; User Responsibility

5
1.3 Electrical Shock
•Nevertouch‘live’electricalparts.
•Alwaysrepairorreplacewornor
damaged parts.
•Disconnectpowersourcebefore
performing any maintenance or service.
•Earthallworkmaterials.
•Neverworkinmoistordampareas.
Avoid electric shock by:
•Wearingdryinsulatedboots.
•Wearingdryleathergloves.
•Workingonadryinsulatedoor
where possible.
1.4 User Responsibility
•ReadtheOperatingManualpriorto
installation of this machine.
•Unauthorisedrepairstothisequipmentmay
endanger the technician and operator and will
void your warranty. Only qualified personnel
approved by BOC should perform repairs.
•Alwaysdisconnectmainspowerbefore
investigating equipment malfunctions.
•Partsthatarebroken,damaged,missingor
worn should be replaced immediately.
•Equipmentshouldbecleanedperiodically.
PLEASE NOTE that under no circumstances
should any equipment or parts be altered
or changed in any way from the standard
specification without written permission
given by BOC. To do so, will void the
Equipment Warranty.
Further information can be obtained
from Welding Institute of Australia
(WTIA) Technical Note No.7
‘Health and Safety Welding’
Published by WTIA,
PO Box 6165 Silverwater NSW 2128
Phone (02) 9748 4443.