RVWM-ADPKIT
Installation Manual
RV Wall Mount Replacement
Radio Mounting Adapter
Plate/Harness Kit.
Radio and radio components not included.
RV5090 / RV5070 to RV6100 / RV6200
®
© Copyright 2019 Magnadyne Corporation
RVWM-ADPKIT-INS Rev. A 8-1-19
4
Installation of RVWM-ADKIT
STEP 6
After the operation check is complete, use the (4)
screws that were removed from the old radio to secure
the radio into the wall plate adapter. DO NOT over
tighten the screws.
STEP 7
Remove the protective film on the face of the
radio (applies to RV6200 only) then snap the
radio trim ring or screw covers back onto the
radio face.
To Next Page
Need help?
General
