Magnaflux Y-6 - User Manual

Questions and Answers

C
Christian MedinaAug 11, 2025
What to do if my Magnaflux Y-6 yoke will not energize?
- E
  Erin GallagherAug 11, 2025
  If your Magnaflux Industrial Equipment yoke does not energize, there are several potential causes. First, ensure the cord is plugged into a grounded outlet or extension cord. If the cord is damaged, contact an authorized service center for repair or replacement. Similarly, a damaged switch should be addressed by a service center. Check for a blown fuse or tripped breaker in the power supply and reset it or replace the fuse. A defective extension cord should be replaced. Finally, check if the GFI has tripped and reset the GFI button.
C
cynthia59Aug 20, 2025
Why Magnaflux Y-6 yoke will not lift test weight?
- B
  Brian WillisAug 20, 2025
  If your Magnaflux Industrial Equipment yoke won't lift the test weight, it might be due to a few reasons. Check the foot sections of the legs; if they are worn or rounded, file or grind them back to their original flat condition, or replace them. Also, ensure the foot sections are properly adjusted to make full contact with the weight. Finally, make sure your extension cord is adequately sized to supply the necessary current.
N
Noah ChaseAug 31, 2025
How to fix still or unmovable legs on Magnaflux Y-6?
- S
  sweberAug 31, 2025
  If the legs on your Magnaflux Industrial Equipment are still or do not move, it could be due to the leg bolts being too tight; loosen them slightly with a properly sized wrench. Alternatively, the legs might be rusted at the joints. In this case, remove the bolts and legs, clean them with a wire brush to remove the rust, and reassemble using a rust remover/preventer. Retighten the bolts until the legs are tight but still move freely.