9
Battery Backup
This alarm clock is equipped with a battery backup feature. This feature will re-
store your alarm clock settings in the event of a power outage. The 3V, CR2032
Flat Lithium battery is pre-installed at the factory, however, should you need to
replace the battery, please read the following instructions.
Installing the Battery
1. Using a small Phillips Head screwdriver, loosen the screw from the battery
panel on the bottom of the unit.
2. Remove the battery compartment panel.
3. Remove/properly dispose of depleted battery and replace with new, 3V,
CR2032 Flat Lithium battery.
4. Close the battery compartment and put screw into place to secure battery panel.
ATTENTION
• When replacing the battery, do not disconnect AC plug from AC outlet.
Current time and alarm will stay the same.
• Do not plug or unplug the power cable if you have wet hands.
• If you are not planning to use the unit for an extended period of time,
disconnect the power cable from the wall outlet.
• Do not pull on the cord! You may damage the power cord and may cause
an electric shock when disconnecting the power cord from the wall outlet.
Pull rmly at the base of the plug.
• Batteries must be installed by an adult.
• Use only the recommended size and type of battery specied.
• Please be sure to follow the correct polarity when installing the
battery in the battery compartment. A reversed battery may cause
damage to the alarm clock.
• When not using the unit for a prolonged period of time, please remove
the battery to avoid possible damage caused by a leaking battery.
To Next Page
Loading...
