1
Connect the supplied video cable to the yellow VIDEO
(VIDEO OUT) jack of the DVD Player and to the TV’s
VIDEO IN jack. The supplied video cable has yellow markings.
2
Connect the supplied audio cable to the red and white
AUDIO OUT jacks on the DVD Player and to the left/right
AUDIO IN jacks on the Stereo. Match the cable colors to the
jack colors.
3
Plug the power cords of the DVD Player, Stereo, and TV
into an active power outlet. Press STANDBY-ON
yy
on the
front of the DVD Player to turn it on.
4
Turn on the Stereo and set it to the correct Audio In
channel or sound source. Refer to the Stereo owner’s manual for
details.
5
Turn on the TV. Set it to the correct Video In channel. See
your TV owner’s manual for details. Or, go to your lowest TV
channel (01 or 02) and change channels downward until you see the
blue DVD screen saver on the TV.
• If you prefer or need to use the
S-VIDEO or Y Pb Pr jacks
instead, see pages 12-13.You
only need one video connection
between the TV and the DVD
Player.
Helpful Hint
To Next Page
Loading...
Need help?
General
