English
34 Operation
Additional Information - DVD
Screen Saver
The screen saver picture appears when you leave the
DVD+VCR in stop mode for about fifteen minutes.
Last Condition Memory
This player memorizes the user settings for the last disc that
you have viewed. Settings remain in memory even if you
remove the disc from the player or switch off the player. If
you load a disc that has its settings memorized, the latest
stop position is automatically recalled.
Notes
""
Settings are stored in memory for use any time.
""
This player does not memorize settings of a disc if you
switch off the player it plays.
Video Mode Setting
Note
The video mode setting only works when the Progressive
Scan mode is set to “On” on the setup menu.
""
With certain discs, the playback picture may be flickering
or Dot Crawl is shown on straight lines. (This means
Vertical interpolation or De-interlace is not perfectly
matched with the disc.) In this case, the picture quality
may be improved by changing the video mode.
""
To change the video mode, press and hold DISPLAY about
3 seconds during disc playback. The new video mode num-
ber selected is displayed on the TV screen. Check
whether the video quality has improved. If not, repeat the
above procedure until picture quality is improved.
""
Video mode sequence:
MODE1
→
MODE2
→
MODE3
→
MODE1
""
If you turn off the power, the video mode will return to
initial default state (MODE1).
Detailed Description of each Video Mode
MODE1 : The source material of the DVD video (film material or
video material) is determined from disc information.
MODE2 : Suitable for playing film based content or video based
material recorded by the progressive scan method.
MODE3 : Suitable for playing video based content with
comparatively little motion.
VCD1.1VCD2.0
DVD
VCD1.1
DVD
To Next Page
Loading...
Need help?
General
