Connect the external source properly to the unit by using input jacks either EXT2 (Front) or EXT1 (Rear).
When connecting an external equipment of monaural output to this unit, use AUDIO L jack of EXT2 (Front).
Use commercially available S-Video or Video cable and an Audio cable for this connection.
Connection to an external source
4. Using [K / L], select “E2 (Front)”. Press [OK].
5. Using [
K / L], select the input jack type to
connect. Press [OK].
If you want to use S-VIDEO input jack, select “S-
Video In”.
If you want to use VIDEO input (Composite) jack,
select “Video In”.
6. Press [SETUP] to exit.
4. Using [
K / L], select “E1 (Rear)”. Press [OK].
5. Using [
K / L], select the input jack type to
connect. Press [OK].
If you want to use S-VIDEO IN jack, select “S-
Video In”.
If you want to use VIDEO IN (Composite) jack,
select “Video In”.
6. Press [SETUP] to exit.
1. Press [SETUP].
2. Using [
K / L], select “Required Settings”. Press [OK].
3. Using [
K / L], select “Video Input”. Press [OK].
or
To Next Page
Loading...
Need help?
General
