EasyManua.ls Logo

Magos MSA1356A - Page 18

Default Icon
21 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
©2023, Magos Systems Ltd. All rights reserved.
Warnings and Disclaimers
General
The SR-series sensor is an electronic radiating product. As such it is not recommended for
installation in densely populated areas, or in the vicinity of such areas. Magos recommends
installation at remote, un-populated, outdoor sites only. In addition, avoid prolonged
unnecessary human contact with the radar and as a rule, it is recommended that the sensor
is installed at a safety distance of at least 3m from any person.
All SR-Series sensors are not suitable for installation in locations where children are likely to
be present.
The SR-Series sensors are not intended for direct connection to the AC power network.
When using power supplies/converters with the sensor that are connected to a local or
national AC power network make sure they are properly isolated and are in full compliance
with your local regulations as well as with POE/POE+ standards as specified in section 4.1.
In any event, Magos will not liable for any damage caused to the product or any
interference caused to the power network resulting from a faulty inappropriate power
supply.
Mechanical installation of the SR-Series sensor is not within the scope of responsibility of
Magos. Magos is not
liable to any damage incurred to the customer and/or to a third party due to faulty
installation (loose bolting/weak brackets etc.).
SR Series sensors are intended for installation in restricted access areas and are installed
and serviced only by skilled personnel qualified by Magos.
Warning!
– hot parts
While handling the device, pay attention to a hot surface.