MAHA MBT 2200 LON User Manual (English)

Questions and Answers:

P
pamelasaundersAug 12, 2025
What to do if MAHA MBT 2200 LON shows error code 33?
- J
  Julie CraigAug 12, 2025
  If your MAHA Test Equipment displays error code 33, there are several potential causes and solutions: * Check the sensors for proper switching clearance and connection. * If the selector switch for '2 measuring directions' (optional) is on position 0, drive the vehicle off the rollers and turn the selector switch to position '1' or '2'. * If the fuse of phase L2 and/or L3 has triggered, switch off the tester and replace the fuses.
H
Holly MurrayAug 16, 2025
What to do if MAHA MBT 2200 LON shows error code 41?
- L
  Lori MendozaAug 16, 2025
  If your MAHA Test Equipment shows error code 41, it is likely that a sensor roller switch is defective. Try re-positioning the vehicle axle and then press the "Power On" key.
S
samueltorresAug 20, 2025
What to do if MAHA Test Equipment shows error code 22?
- E
  eric92Aug 20, 2025
  If your MAHA Test Equipment displays error code 22, position the overload protection switch(es) to 1, then switch the main switch OFF and then ON again.
N
Nathan MunozAug 25, 2025
What to do if MAHA MBT 2200 LON Test Equipment shows error code 32 1)?
- B
  brandonmooreAug 25, 2025
  If your MAHA Test Equipment displays error code 32 1), it indicates that the left-side speed sensor is defective. Check the sensor for switching clearance and proper contact of connections.
A
Amanda AndersonAug 27, 2025
What to do if MAHA MBT 2200 LON shows error code 34 1)?
- E
  evanjohnsonAug 27, 2025
  If your MAHA Test Equipment displays error code 34 1), it indicates that the right-side speed sensor is defective. Check the sensor for switching clearance and proper contact of connections.
A
Alyssa LarsonAug 31, 2025
What to do if MAHA Test Equipment shows error code 44 2)?
- L
  leehansenAug 31, 2025
  If your MAHA Test Equipment is showing error code 44 2), position the reflector strips correctly, as the light barrier may be defective.
D
dennisrachaelSep 4, 2025
What to do if MAHA Test Equipment shows error code 40?
- J
  Jonathan MillerSep 4, 2025
  If your MAHA Test Equipment shows error code 40, drive the vehicle off the rollers, turn off the main switch, and then turn it back on again.
L
Lisa GonzalesSep 7, 2025
What to do if MAHA MBT 2200 LON shows error code 51?
- E
  Edward ChristianSep 7, 2025
  If your MAHA Test Equipment displays error code 51, and the driven axle of the vehicle is on the roller set, start the rollers using the remote control and exit the test stand.