I-3
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Hydraulics
1. SPECIFICATION
a) Pump
1. Make ---------------------------------------------------------- EATON
2. Type ----------------------------------------------------------- Gear
3. Output @ 2800 RPM ------------------------------------ 41 lpm (11 gpm)
b) Hydraulic Lift Unit
1. Make ---------------------------------------------------------- MITA
2. Lift Cylinder ID --------------------------------------------- 85 mm
3. System Relief Valve Pressure @ 40 lpm ----------- 200 (+5/-0) bar
4. Shock Load Relief Valve Setting ---------------------- 225 - 230 bar
5. Bell Crank Pin Hole --------------------------------------- 19.5 mm
6. Suction Strainer Size ------------------------------------- 100 mesh
7. Suction Filter Size ----------------------------------------- 10 micron
Features
i) Position and Draft Control
ii) Lowering speed adjustment of Lifting Arm
iii) Common oil for Transmission, Hydraulic and Power Steering
iv) Common Relief Valve for Hitch Valve, Auxiliary Valve and Loader Valve
TECHNICAL FEATURES
• Operation with draft and position control.
• Reading of traction force on top link.
• Adjustment of operating sensibility during
draft control work.
• Lowering speed adjustment of lifting arms.
• Safety transport lock on control valve.
• Automatic hydraulic limit stop of angular
excursion of lifting arms.
• Sector control with two levers: One lever for
the position and one for the draft control.