Mahindra 35 Series User Manual

I-30
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
Hydraulics
15. REMOVE, INSPECT AND INSTALL HYDRAULIC
LIFT ARMS, ROCKSHAFT, ROCKER ARM, SEAL
1. Remove Hydraulic Lift Unit as per the guided
procedure as given in point no.11.
2. Remove position and draft control linkages
levers by loosening lock clips and washers.
3. Rotate lift arms to access and remove setscrew
(A) in crank (B).
4. Remove snap ring (C) and arm (D) from
opposite side of control levers on hydraulic.
NOTE: Index parts to hydraulic with a punch
mark before disassembly, to aid in correct
alignment of these parts during assembly.
Slightly tap lift arms to take out.

Mahindra 35 Series Specifications

General

Cylinders	3
Transmission	8 Forward + 2 Reverse
Fuel Type	Diesel
Brake Type	Oil Immersed
Brakes	Oil Immersed
Steering	Power Steering
Drive Type	2WD
Engine Type	Diesel
Steering Type	Power
Fuel Tank Capacity	45 liters