C-17
35 Series 4WD, Model - 3535, 4035, 4535 and 5035 SM June’08
3. Sling the engine securely. Hoist the engine into
position in front of the clutch housing and enter
the transmission drive shaft into the clutch
assembly.
4. Move engine back turning the transmission and
P.T.O. drive shaft to engage the splines of the
clutch driven members, until the shaft is located
in the pilot bearing and the clutch housing is
located on the crankcase dowels.
NOTE: When engine is removed from tractor. Chassis
for overhauling always take out the starter
motor the alternator & the hydraulic pump and
send them for testing.
5. Insert, and tighten the attaching bolts.
NOTE: To assist assembly, two longer bolts may be
used to guide and to draw the engine upto
the clutch housing.
6. Installation is now the reversal of the removal
procedure by using new parts with kit.
7. Fill the cooling system and check the air cleaner
oil, engine oil, hydraulic oil, fuel and then bleed
the diesel fuel system.
Introduction