© Copyright Mahindra and Mahindra Ltd. 062016
12-11
12.5.6 Checking/Topping Brake Fluid
C
L
E
A
N
F
I
L
L
E
R
C
A
P
B
E
F
O
R
E
R
E
M
O
V
I
N
G
MAX
MAX
MIN
MIN
W
A
R
N
I
N
G
-
-
U52N08
The brake system is supplied with brake fluid from the brake fluid
reservoir located adjacent to the air filter.
The brake fluid level will drop slowly as the brakes wear, and will rise
when the brake components are replaced. Fluid levels between the
‘MIN’ and ‘MAX’ lines are within the normal operating range; there
is no need to add fluid. If the fluid levels are below the ‘MIN’ mark,
the performance of the systems could be compromised; the brake
operation could be spongy.
Top-up the recommended brake fluid till the ‘MAX’ mark or contact
an Authorized Mahindra Dealer immediately.
Carefully clean the cap on the reservoir before you remove it and be
sure no debris fall in the reservoir. Do not keep the reservoir open
for longer than necessary to add brake fluid.
Use only brake fluid that meets Mahindra specifications. Refer to
the ‘Lubricant and Capacities’ section.
Draining or changing of brake fluid should always be done by an
Authorized Mahindra dealer.
12.5.7 Checking/Topping Clutch Fluid
The clutch system is supplied with clutch fluid from the clutch fluid
reservoir located adjacent to the brake fluid reservoir on the
firewall.
Fluid levels between the ‘MIN’ and ‘MAX’ lines are within the normal
operating range; there is no need to add fluid. If the fluid levels are
below the ‘MIN’ mark, the performance of the systems could be
MAINTENANCE
To Next Page
Loading...
Need help?
General
