EasyManuals Logo

Maico MI 24 User Manual

Maico MI 24
71 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
Operation Manual
touchTymp MI 24
and
MI 34
Version
8107420 Rev. 6
03/09/2018
In order to maintain a high level of safety and to ensure the
device works properly, it is necessary to have the device
and its power supply checked according to the medical
electrical safety standard IEC 60601-1 by a qualified
service technician at least once a year. For more
information see section 3.2.
The use of non-calibrated devices can lead to incorrect test
results and is not advisable.
Prevent cable breakage: cables must not be bent or buckled.
2.7 Device Control
The user of the device should perform a subjective device check once a week
according ISO 8253-1.
For annual calibration see section 2.5 and 3.2.
2.8 Electromagnetic Compatibility (EMC)
Electrostatic discharge (ESD) according to IEC 61000-4-2.
Use the device only in an electrostatic controlled
environment.
To avoid the risk of electric shock, this equipment must
only be connected to supply mains with protective earth.
The device fulfills the relevant EMC requirements. Avoid
unnecessary exposure to electromagnetic fields, e.g. from
mobile phones etc. If the device is used adjacent to other
equipment it must be observed that no mutual disturbance
appears.
Please also refer to EMC consideration in section 6.5.
CAUTION
WARNING

Other manuals for Maico MI 24

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Maico MI 24 and is the answer not in the manual?

Maico MI 24 Specifications

General IconGeneral
BrandMaico
ModelMI 24
CategoryMeasuring Instruments
LanguageEnglish