Memory Height Inching and Continuation Switching
In the reset state, that is, the hand controller shows the "RST".
Long press button 1 to switch between memory height inching and memory
height continuation.
The hand controller displays "10.1", which is the memory height continuation.
The hand controller displays "10.2", which is the memory height inching.
CM-INCH Conversion
In the reset state, that is, the hand controller shows the "RST".
Long press button 2 to switch between centimeters and inches.
The hand controller displays "10.3", and the height will display in
cm after reset.
The hand controller displays "10.4", and the height will display in
inch after reset.
Obstructed Blocked Back Sensitivity Selection
In the reset state, the hand controller shows the "RST".
Long press the up button to change the fallback sensitivity in case of resistance.
The hand controller shows:
"10.5" -- 22 lbs
"10.6" -- 33 lbs
"10.7" -- 44 lbs
USB Interface
Output Voltage: 5V
Output Current: 0.8A
USB
“RST” “10.1/10.2”
“RST” “10.3/10.4”
long-press 5s
long-press 5s
long-press 5s
“RST” “10.5/10.6/10.7”
To Next Page
Loading...
