Makeblock mDrawBot Kit - Screw M4×16; Nut M4

4
(1)
(1)
(1)
Nut M2(2)
Screw M2×10(2)
(1)
5
The long side is upturned.
The short side is downturned.
Steering Wheel
※You can change the installation angle of the Steeling Wheel to
adjust the height of pen.
Screw M4×16(2)
Nut M4(2)
Two plates are
joint together.
6
(1)
XO
※Pay attention to the direction when you installing the Square Nut
M4,otherwise the Pen Holder will be broken.
7
Screw M4×16(1)
8
(1)
(1)
The long side.
mScara mSpider mEggbot mCar
mScara
Structure Diagram
Motor B
Motor A
Desk
1
Screw M4×8(2)
(1)
(1)
4×7×3(2)
2
Screw M4×8(2)
(1)
(1)
3
Screw M4×16(2)
(1)
(1)
Nut M4(2)
4
Screw M4×8(1)
Nut M4(1)
5
Screw M4×8(4)
(2)
Plastic Gasket
4×7×3
Flange Bearing
4×8×3
Make sure all the
three parts are
properly aligned.
Make sure all the
three parts are
properly aligned.
1
2
2
Threaded Hole
Threaded Hole
11
10
Note: Make sure to assemble the robot in strict accordance with the requirements
from P5 - P7, otherwise it may result in inaccuracy or poor performance.