MAKEiD L1-A - User Manual

MAKEID L1-A
QUICK OPERATIONAL MANUAL
Chongqing Jingranyouxu Technology Co., Ltd.
Web: WWW.MAKEID.COM
Under the environment with Electrostatic Discharge
Test Results the sample may be disconnected, but
it can be resumed to normal operation by user after
test.
Operation is subject to the following two conditions:
(1)
This device may not cause harmful interference, and
(2)This device must accept any interference received,
including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. lf this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
off and on, the user is encouraged to try to correct
the interference by one or more of the followingme-
sures:
-Reorient or relocate the receivingantenna.
- lncrease the separation between the equipment
andreceiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF
exposure requirement. The device can be used
in portable exposure condition without restriction.
Warning: Changes or modifications to this unit not
expressly approved by the part responsible for com-
pliance could void the user' s authority to operate
the equipment.
This device complies withpart 15 of the FCC Rules.

Summary

FCC Compliance Information

Part 15 Rules Statement

Device adheres to FCC Part 15, requiring no harmful interference and accepting received interference.

RF Exposure Statement

The device meets general RF exposure requirements for portable use without restriction.

Product Introduction

Component Identification

Lists and describes the physical parts of the device, including buttons and ports.

Indicator and Charging Guide

Explains indicator light meanings and provides charging instructions for the device.

Label Installation Steps

Provides step-by-step instructions for correctly loading label paper into the printer.

Connecting and Printing

Phone Connection Procedure

Outlines the steps to connect the smartphone to the printer via Bluetooth using the APP.

Continuous Label Printing

Instructions for printing on continuous label rolls using the APP interface.

Gapped Label Printing

Guide for printing on gapped label rolls, including size selection and editing.

Label Usage and Troubleshooting

Connection Troubleshooting

Provides solutions for common issues preventing phone-to-printer Bluetooth connection.

Printing Quality Troubleshooting

Addresses issues like blurred printing, offering advice on temperature and density.

Two-Year Product Warranty

Explains the warranty coverage, requirements for service, and limitations.

MAKEiD L1-A Specifications

General

Print Technology	Thermal Transfer
Print Resolution	203 dpi
Max. Print Width	12 mm
Connectivity	Bluetooth
Label Types	Continuous, Die-cut
Power Source	Rechargeable Lithium Battery
Label Width	6 mm, 9 mm, 12 mm