57
TROUBLESHOOTING
TROUBLESHOOTING + MAINTENANCE
PROBLEM SOLUTION
You receive a “MultiScan
Failed” message.
MultiScan Technology could fail to merge your
scans if:
• You attempted to combine scans of two
dierent objects
• Lighting conditions changed between your
first and second scans
• Your object is fuzzy, reflective, transparent,
or very dark, and produced widely dierent
sets of scan data for each scan.
MultiScan Technology should only be used to
combine scans of the same object, scanned
under similar conditions. If MultiScan
Technology fails to merge your scans,
MakerWare for Digitizer will revert your scan to
its previous state.
To Next Page
Loading...