Change Filament: Preheat PLA –Preheats the hotend to a
temperature suitable for PLA material changes ； Preheat ABS
–Preheats the hotend to a temperature suitable for ABS material
changes； Preheat Custom –Preheats to a custom temperature to
change (Choosing these three options will unload filament and
re-start to load filament)
Load Filament ： Preheat PLA –Preheats the hotend to a
temperature suitable for PLA to load； Preheat ABS –Preheats the
hotend to a temperature suitable for ABS to load；Preheat Custom
based on custom temperature to load.
Unload Filament：Preheat PLA based on PLA suitable temperature
to unload ； Preheat ABS based on ABS suitable temperature to
unload；Preheat Custom based on custom suitable temperature to
unload.
To Next Page
Loading...
