11 ENGLISH
Speed adjusting dial
-
ber on the dial and the corresponding rotation speed.
Fig.3: 1.
Only for model 9564PCV / 9565PCV
Number Speed
1 2,800 min
-1
2 4,000 min
-1
3 6,500 min
-1
4 9,000 min
-1
5 12,000 min
-1
Only for model 9566PCV
Number Speed
1 4,000 min
-1
2 5,000 min
-1
3 6,500 min
-1
4 8,000 min
-1
5 10,000 min
-1
NOTICE: If the tool is operated continuously at
low speed for a long time, the motor will get over-
loaded, resulting in tool malfunction.
NOTICE:
The speed adjusting dial can be turned
only as far as 5 and back to 1. Do not force it past 5 or
1, or the speed adjusting function may no longer work.
Soft start feature
Soft start feature reduces starting reaction.
Constant speed control
Overload protector
When the load on the tool exceeds admissible levels, power to the
motor is reduced to protect the motor from overheating. When the
load returns to admissible levels, the tool will operate as normal.
ASSEMBLY
CAUTION: Always be sure that the tool is
any work on the tool.
Installing side grip (handle)
CAUTION: Always be sure that the side grip is
installed securely before operation.
Fig.4
Installing or removing wheel guard
WARNING: When using a depressed center
the closed side of the guard always points toward
the operator.
WARNING:
/ diamond wheel, be sure to use only the special
For tool with locking screw type
wheel guard
Mount the wheel guard with the protrusions on the
wheel guard band aligned with the notches on the bear-
ing box. Then rotate the wheel guard to such an angle
that it can protect the operator according to work. Be
To remove wheel guard, follow the installation proce-
dure in reverse.
Fig.5: 1. Wheel guard 2. Bearing box 3. Screw
For tool with clamp lever type wheel
guard
Loosen the screw, and then pull the lever in the direc-
tion of the arrow. Mount the wheel guard with the protru-
sions on the wheel guard band aligned with the notches
on the bearing box. Then rotate the wheel guard to such
an angle that it can protect the operator according to
work.
Fig.6: 1. Wheel guard 2. Bearing box 3. Screw
4. Lever
Pull the lever in direction of the arrow. Then tighten the
wheel guard with fastening the screw. Be sure to tighten
Fig.7: 1. Screw 2. Lever
To remove wheel guard, follow the installation proce-
dure in reverse.
Clip-on cutting wheel guard
attachment
Optional accessory
NOTE:
wheel guard attachment can be used with the wheel
Not available in some countries.
Fig.8
To Next Page
Loading...
