There may be local regulations concerning noise
which must be complied
with
by keeping noise levels
within
prescribed limits.
In
certain cases, shutters
should be used to contain noise.
Do
not tamper
with
the tool or attempt to use
it
for
other than nailing.
Do
not play
with
the contact
element;
it
prevents accidental discharge,
so
it
must
be kept on and not removed. Securing the trigger
in
the ON position is also very dangerous. Never
attempt to fasten the trigger.
Operate the tool
within
the specified air pressure of
4.0
-
8.5
kgf/cm*G
(60
-
120
PSIG) for safety
and longer tool life.
Do
not exceed the recommended
max. operating pressure of
8.5
kgf/cm’G
(120
PSIG). The tool should not be connected to a source
whose pressure potentially exceeds
14.0
kgf /cm’G
(200
PSIG).
Never use the tool
with
other than compressed air.
If high-pressure gas (carbon dioxide, oxygen, nitro-
gen, hydrogen, propane, acetylene, etc.) is used as
a power source for this tool, the tool
will
explode
and cause serious injury.
-Contact element
120
PSIG
120
PSIG
COMPRESSED
AIR
4
To Next Page
Loading...
Need help?
General
