Makita AN8300 User Manual

Pneumatic Framing Nailer
Dimensions Min hose
Air pressure Nail length Nail capacity IL x H x Wl diameter
MODEL AN8300
Net
weight
INSTRUCTION MANUAL
4.2 ~ 8.5 kgf1cmZG
(60 - 120 PSIG)
8.5 mm 3.6 kg
51 mm - 90 mm
64 - 74 pes,
544mmx349mmx 112mm
(2"
- 3-112") (21-13132" x 13-314" x 4-13/32',) (11132") (7.9 lbsl
* Manufacturer reserves the right to change specifications without notice.
*Note: Specifications may differ from country to country.
*3-1/2" nail: Use for soft workpieces only.

Makita AN8300 Specifications

General

Brand	Makita
Model	AN8300
Category	Nail Gun
Language	English

Summary

Pneumatic Framing Nailer Specifications

Important Safety Instructions

Read Manual First

Mandatory Protective Gear

Always wear safety glasses (ANSI Z87.1) and hearing protection to prevent injuries and noise damage.

General Tool Handling Guidelines

Safe Handling and Operation Rules

Assume tool is loaded, do not point carelessly, respect tool, avoid horseplay, and proper transport.

Operating Conditions and Precautions

Noise Regulations and Tool Tampering

Air Pressure and Power Source

Operate within specified air pressure (60-120 PSIG). Use only compressed air, not flammable gases.

Pre-Operation Checks and Hazard Awareness

Tool Condition and Safety System Verification

Check tool for loose screws and ensure all safety systems function correctly before operation.

Work Area Hazard Inspection

Usage Restrictions and Workplace Safety

Bystander Safety and Footing

Final Operational Safety Warnings

Ejection Port and Trigger Safety

Do not point ejection port at anyone. Keep finger off trigger when hose is connected.

Tool Handling and Malfunction Response

Handle tool carefully due to internal pressure. Stop operations immediately if any abnormality is noticed.

Tool Installation and Use

Lubrication and Air Set Installation

Loading Nailer Procedure

Disconnect air hose before loading. Pull pusher to lock lever. Insert nail strips, ensuring overlap.

Compressor and Air Hose Selection

Selecting the Right Air Compressor

Choose a compressor with ample pressure and output. Use regulators to match tool's rated pressure.

Choosing and Connecting the Air Hose

Operation Procedures

Nailing Methods

Jammed Nailer Troubleshooting

Disconnect air, remove nails. Use rod and hammer to retract driver, then pliers to remove jammed nail.

Maintenance and Care

Nailer Maintenance Procedures