Always check the tool for its overall condition and
loose screws before operation. Tighten as required.
Make sure all safety systems are
in
working order
before operation. The tool must not operate if only
the trigger
is
pulled or if only the contact arm is
pressed against the wood.
It
must work only when
both actions are performed. Test for possible faulty
operation
with
nails unloaded and with the pusher
locked at fully pulled position.
@Check walls, ceilings, floors, roofing and the like
carefully to avoid possible electrical shock, gas
leakage, explosions, etc. caused by striking lives
wires, conduits or gas pipes.
Pusher
/
I
Pusher
Live
wire
To Next Page
Loading...
