EasyManuals Logo

Makita DF332D User Manual

Makita DF332D
12 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9 ENGLISH
Useacuttinglubricantwhendrillingmetals.Theexcep-
tions are iron and brass which should be drilled dry.
CAUTION: Pressing excessively on the tool
will not speed up the drilling. In fact, this excessive
pressure will only serve to damage the tip of your drill
bit, decrease the tool performance and shorten the
service life of the tool.
CAUTION: Hold the tool rmly and exert care
when the drill bit begins to break through the
workpiece.Thereisatremendousforceexertedon
thetool/drillbitatthetimeofholebreakthrough.
CAUTION: A stuck drill bit can be removed
simply by setting the reversing switch to reverse
rotation in order to back out. However, the tool
may back out abruptly if you do not hold it rmly.
CAUTION: Always secure small workpieces
in a vise or similar hold-down device.
CAUTION: If the tool is operated continuously
until the battery cartridge has discharged, allow
the tool to rest for 15 minutes before proceeding
with a fresh battery.
Using the tool as a hand screwdriver
Switch off the tool.
Move the reversing switch lever to the neutral position.
Turntheadjustingringsothatthearrowpointsto
the marking.
Turnthetool.
NOTE:Thisuseisconvenientforcheckingthe
screwdriving.
NOTE:Donotusethetoolforworkrequiringexces-
sive force, such as tightening bolt or removing rusted
screws.
Using holster
Optional accessory
CAUTION: When using the holster, remove a
driver bit/drill bit from the tool.
CAUTION: Turn off the tool and wait until it
comes to a complete stop before placing it in the
holster.
Be sure to close the holster securely with the
holster button so that it holds the tool rmly.
1. Threadawaistbeltorsimilarthroughholster
holder.
1
2
1. Holster holder 2. Waist belt
2. Putthetoolintheholsterandlockitwiththehol-
ster button.
You can keep two driver bits at the front of the holster.
MAINTENANCE
CAUTION: Always be sure that the tool is
switched off and the battery cartridge is removed
before attempting to perform inspection or
maintenance.
NOTICE: Never use gasoline, benzine, thinner,
alcohol or the like. Discoloration, deformation or
cracks may result.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Makita DF332D and is the answer not in the manual?

Makita DF332D Specifications

General IconGeneral
Soft gripYes
Product designPistol grip drill
Number of gears2
Torque settings21
Chuck capacity (max)10 mm
Chuck capacity (min)0.8 mm
Sound pressure level72 dB
Idle speed (1st gear)450 RPM
Idle speed (2nd gear)1500 RPM
Drilling diameter in wood (max)28 mm
Maximum torque (hard applications)35 N⋅m
Maximum torque (soft applications)21 N⋅m
Number of batteries included2 pc(s)
Power sourceBattery
Battery voltage10.8 V
Battery capacity2 Ah
Weight and Dimensions IconWeight and Dimensions
Depth154 mm
Width66 mm
Height236 mm
Weight1200 g

Related product manuals