9 ENGLISH
Adjusting the fastening torque
When you wish to drive machine screws, hex bolts, etc. with the
predetermined torque, adjust the fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Loosen and remove the screw that secures the
ring and lamp cover.
1
2
►1. Screw 2. Lamp cover
3. Rotate the ring in the front of the tool by hand so
that a hole can be seen below the ring.
1
►1. Ring
4.
Install the battery cartridge in place. Pull the switch
trigger and release it so that the adjust ring rotates and the
hole becomes visible. And then remove the battery cartridge.
1
2
►1. Adjust ring 2. Hole for adjust grip
5. Use an optional adjust grip to adjust the fastening
torque. Insert the pin of the adjust grip into the hole
in the front of the tool. And then, turn the adjust grip
clockwise to set a greater fastening torque, and coun-
terclockwise to set a smaller fastening torque.
6. Align the yellow line with your desired number on
the fastening torque scale.
2
1
3
4
►1. Adjust grip 2. Hole for adjust grip 3. Scale
4. Yellow line
7. Insert the battery cartridge and be sure that a
fastening torque has been set up by using a fastening
torque tester.
8. Rotate the ring in front of the tool and then tighten
the screw to secure the ring and lamp cover.
NOTE: Numbers on the fastening torque scale is a
guideline to set up your desired fastening torque.
Adjusting no-load speed and
revolution angle etc.
You can adjust the no-load speed, number of turn, etc.
of the tool with your computer. Install the application
software in your computer and connect it to the tool with
an USB cable.
2
3
1
►1. USB cable 2. USB cover 3. USB port
NOTICE: Make sure that the USB cover closed
when fastening.
NOTE: For the application software, please contact
Makita sales representative.
To Next Page
Loading...
Need help?
General
