CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.
P 2/ 13
Apply Makita grease N. No.2 to the following portions designated with the black triangle to protect parts and product
from unusual abrasion.
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Motor section
[1] NECESSARY REPAIRING TOOLS
Code No. Description Use for
1R022 Bearing plate (for Arbor press) supporting Helical gear 31 when removing the gear with 1R279
1R268 Spring pin extractor M3 locking Cutter shaft when removing Cutter assembly
1R279 Round bar for arbor 5-50 removing Helical gear 31
[2] LUBRICATION
Fig. 1
Item No. Description Amount
approx. 3 g
Portion to lubricate
DISASSEMBLING
69 Motor housing set Gear room where Helical gear 31 engages with Armature’s gear
(1) Remove the accessories and attachment from Motor housing as drawn in Fig. 2.
56
1R268Motor housing
1. While inserting 1R268 into the hole
of Motor housing set to stop Cutter
shaft revolving, turn Cutter assembly
clockwise by hand.
Cutter assembly is removed from
Cutter shaft.
2. Remove Guard and
Receive washer from
Cutter shaft.
3. Remove Wire guard by opening
the both ends. Then, unscrew
two M6x30 Hex socket head bolts
and Washers, then remove Protector
and Protector holder.
Cutter
assembly
Guard
Washer
(2 pcs.)
Receive washer
Insertion hole
for Spindle lock
Cutter assembly
Wire guard
Protector holder
Protector
M6x30
Hex socket
head bolt
(2 pcs.)
Fig. 2
56
69
Helical gear 31
Armature’s gear
Repair
To Next Page
Loading...
