To Next PageTo Next PageWhat to do if my Makita EA3201S engine starts then dies immediately?
If your Makita Chainsaw engine starts but then dies immediately, this may be due to an incorrect idling adjustment, or a dirty suction head or carburetor. Try adjusting the idling and cleaning the suction head or carburetor.
Why is my Makita EA3201S Chainsaw chain not getting oil?
If your Makita Chainsaw chain isn't getting lubrication, the oil tank might be empty, the oil guide groove could be dirty, or the oil pump adjusting screw might be incorrectly adjusted. Refill the oil tank, clean the oil guide groove, and adjust the oil pump to resolve this.
How to fix warm start difficulties in Makita EA3201S?
Warm start difficulties with your Makita Chainsaw can be caused by a wrong carburetor adjustment. Adjust the carburetor to resolve this issue.
Why Makita EA3201S Chainsaw has insufficient power?
If your Makita Chainsaw isn't delivering enough power, the cause may be a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a blocked exhaust channel in the cylinder, or a clogged spark arrester screen. To resolve this, clean or replace the air filter, adjust the carburetor settings, and clear any blockages in the muffler, exhaust channel, and spark arrester screen.
Why is there no chain lubrication in my Makita EA3201S?
If your Makita Chainsaw chain isn't getting lubrication, it could be due to an empty oil tank, a dirty oil guide groove, or an incorrectly adjusted oil pump. Refill the oil tank, clean the oil guide groove, and adjust the oil pump as needed.
How to fix insufficient power in my Makita EA3201S Chainsaw?
If your Makita Chainsaw has insufficient power, the air filter might be dirty, the carburetor might be wrongly adjusted, the muffler could be clogged, the exhaust channel in the cylinder could be clogged, or the spark arrester screen might be clogged. To resolve this, clean or replace the air filter, adjust the carburetor, and clear any clogs in the muffler, exhaust channel, or spark arrester screen.
Why won't my Makita Brush Cutter start, or starts with difficulty?
General| Bar Length | 35 cm |
|---|---|
| Chain Pitch | 3/8 inch |
| Weight | 4.1 kg |
| Power Output | 1.35 kW |
| Fuel Tank Capacity | 0.4 L |
| Chain Gauge | 0.050 inch |
| Oil Tank Capacity | 0.28 L |
Details owner's and manufacturer's responsibilities for emission control systems.
Lists components covered under evaporative and exhaust emission warranties.
Explains various symbols used on the saw and in the manual for safety.
Key safety rules for operating the chain saw and avoiding injury.
Recommended attire and personal protective equipment for safe operation.
Covers engine starting, stopping, fueling, and basic operating instructions.
Explains forces like kickback, pushback, and pull-in during operation.
Strategies and devices to reduce kickback risk and potential injury.
Steps for installing the guide bar and saw chain correctly.
How to properly tension and check the saw chain.
How to check the proper function of the chain brake before use.
Guidelines and techniques for sharpening the saw chain.
Procedures for cleaning the air filter and replacing the spark plug.
Procedures for replacing the starter cable and related components.
Solutions for common malfunctions and operational problems.
Details on obtaining spare parts and contacting service centers.
