What to do if my Makita Saw starts then dies?
If your Makita Saw starts but dies immediately, the issue might stem from an incorrect idling adjustment, a dirty suction head or carburetor, a defective tank venting system, an interrupted fuel line, a defective cable, or a defective combination switch. To resolve this, clean the suction head and carburetor, and check the tank venting and fuel line.
Why my Makita Chainsaw engine does not start?
If your Makita Chainsaw engine is not starting, begin by checking the ignition spark. Also inspect the wiring, and replace the spark plug or cap if defective. Ensure proper spark plug sealing. Adjust the combination switch and clean the carburetor if the combination switch is in Choke position, or if the carburetor is defective, or the suction head is dirty, or the fuel line is bent or interrupted. Finally, inspect the starter and engine parts, and replace defective components if the cylinder base packing ring or radial shaft packings are defective, or if the cylinder or piston rings are defective.
How to fix insufficient power in Makita Saw?
If your Makita Saw has insufficient power, the cause might be a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen. Clean or replace the air filter and muffler.
What to do if my Makita EA3500S has insufficient power?
If your Makita Chainsaw has insufficient power, it might be because the air filter is dirty, the carburetor adjustment is wrong, the muffler is clogged, the exhaust channel in the cylinder is clogged, or the spark arrester screen is clogged. Clean the air filter and check the carburetor adjustments.
What to do if my Makita EA3500S engine starts, but dies immediately?
If your Makita Chainsaw engine starts but dies immediately, the idling adjustment might be wrong, or the suction head or carburetor could be dirty. Check and adjust the idling settings and clean the suction head or carburetor. Another possibility is a defective tank vent, an interrupted fuel line, a defective cable, or a defective combination switch. Inspect the tank vent and ensure the fuel line is not interrupted.
How to fix warm start difficulties with my Makita EA3500S Chainsaw?
If you're experiencing warm start difficulties with your Makita Chainsaw, it's likely due to an incorrect carburetor adjustment. Adjust the carburetor settings.
How to fix warm start difficulties on my Makita EA3500S?
If you're experiencing difficulties starting your Makita Chainsaw when it's warm, it could be due to an incorrect carburetor adjustment. To fix this, adjust the carburetor accordingly.
Why is there no chain lubrication in my Makita Saw?
If your Makita Saw isn't lubricating the chain, it could be due to an empty oil tank, a dirty oil guide groove, or an incorrectly adjusted oil pump adjusting screw. Fill the oil tank, clean the oil guide groove, and adjust the oil pump.
What to do if my Makita EA3500S engine does not start?
If the engine of your Makita Chainsaw doesn't start or starts with difficulty, there could be a malfunction in the fuel supply system, compression system, or a mechanical malfunction. Check the ignition spark, fuel tank, and starter engagement. Also, inspect for any wiring faults.
How to solve warm start difficulties with Makita EA3500S Chainsaw?
If you are experiencing warm start difficulties with your Makita Chainsaw, it may be due to a wrong carburetor adjustment. Adjust the carburetor to resolve this issue.
General| Weight | 4.6 kg |
|---|---|
| Chain Pitch | 3/8 inch |
| Bar Length | 35 cm |
| Fuel Tank Capacity | 0.48 liters |
| Oil Tank Capacity | 0.28 L |
| Power Rating | 1.7 kW |
| Chain Gauge | 0.050 inch |
To Next Page
