How to solve warm start difficulties with Makita EA3501S Chainsaw?
If you are experiencing warm start difficulties with your Makita Chainsaw, it may be due to a wrong carburetor adjustment. Adjust the carburetor to resolve this issue.
What to do if Makita EA3501S engine starts, but dies immediately?
If your Makita Chainsaw starts but dies immediately, it could be due to a wrong idling adjustment, or a dirty suction head or carburetor. Adjust the idling and clean the suction head or carburetor. Also, check the tank venting and fuel line, as a defective tank venting, interrupted fuel line, defective cable or combination switch could also be the cause.
How to fix insufficient power in Makita EA3501S?
If your Makita Chainsaw has insufficient power, the air filter may be dirty, the carburetor adjustment may be wrong, the muffler may be clogged, the exhaust channel in the cylinder may be clogged, or the spark arrester screen may be clogged. To resolve this, clean the air filter and muffler, and adjust the carburetor.
Why Makita EA3501S Chainsaw engine does not start?
Several issues can prevent your Makita Chainsaw engine from starting. It could be a malfunction in the fuel or compression system, or a mechanical malfunction. Inspect the ignition system, fuel supply, and compression system. Also, the STOP switch might be in the wrong position, or there could be a fault in the wiring, or a defective spark plug. Inspect the STOP switch and wiring for faults. Ensure the combination switch is not in the choke position, and clean the carburetor and fuel line if they are dirty. Defective cylinder base packing rings, radial shaft packings, or cylinder/piston rings can also be the cause. Inspect and replace any defective packing rings. A spark plug that doesn't seal should be replaced. Finally, check the starter spring and engine for any broken parts.
How to fix insufficient power in my Makita EA3501S?
If your Makita Chainsaw has insufficient power, it could be due to a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen. To resolve this, clean the air filter, adjust the carburetor, and unclog the muffler, exhaust channel, and spark arrester screen.
Why is my Makita EA3501S Chainsaw chain not running?
If the chain on your Makita Chainsaw isn't running, the chain brake might be activated. Check if the chain brake is in the 'off' position.
How to fix warm start difficulties with my Makita EA3501S?
If you're experiencing warm start difficulties with your Makita Chainsaw, it's likely due to an incorrect carburetor adjustment. Adjust the carburetor settings.
What to do if my Makita EA3501S Chainsaw engine starts, but dies immediately?
If your Makita Chainsaw engine starts but dies immediately, the idling adjustment might be wrong, or the suction head or carburetor could be dirty. Check and adjust the idling settings and clean the suction head or carburetor. Another possibility is a defective tank vent, an interrupted fuel line, a defective cable, or a defective combination switch. Inspect the tank vent and ensure the fuel line is not interrupted.
Why is there no chain lubrication in my Makita EA3501S?
If there is no chain lubrication in your Makita Chainsaw, the oil tank might be empty, the oil guide groove might be dirty, or the oil pump adjusting screw might be incorrectly adjusted. Fill the oil tank, clean the oil guide groove, and adjust the oil pump screw.
How to fix warm start difficulties in Makita EA3501S?
Warm start difficulties in your Makita Chainsaw may be due to a wrongly adjusted carburetor. Adjust the carburetor to resolve this issue.
To Next Page
General
