To Next Page
J
Jeffrey HunterSep 6, 2025
What to do if my Makita EB5300TH Blower has a detached control cable?
- MMrs. Nicole AndersonSep 6, 2025
Attach the control cable securely.
What to do if my Makita EB5300TH Blower has a detached control cable?
Attach the control cable securely.
How to fix a Makita Blower that won't start?
If your Makita Blower engine won't start, several factors could be at play. First, ensure you've primed the pump by pushing it 7 to 10 times. A low pulling speed of the starter rope can also prevent starting, so pull strongly. Check for a lack of fuel and replenish if needed. A clogged fuel filter can be cleaned or replaced. Bent fuel tubes should be straightened. If the fuel is old (more than a month), replace it. For excessive fuel suction, adjust the throttle lever from medium to high speed and try starting. Also, ensure the plug cap is securely attached and the spark plug is clean and properly gapped, replacing it if necessary. If none of these steps work, there may be an issue with the carburetor, starter knob, or internal engine parts, requiring professional inspection.
How to fix a Makita EB5300TH throttle that does not return to idling speed?
If the throttle on your Makita Blower doesn't return to idling speed, it may be caused by an improper throttle valve position. Reposition the control cable.
What to do if my Makita EB5300TH engine stops soon after starting?
If your Makita Blower engine stops soon after starting or the engine speed does not increase, consider the following: * **Warm-up:** Perform the warm-up operation. * **Choke lever:** Ensure the choke lever is set to “OPEN” after the engine warms up. * **Fuel filter:** Clean the fuel filter if it’s clogged. * **Air cleaner:** Clean the air filter if it's contaminated or clogged. * **Control cable:** Securely attach any detached control cables.
What to do if my Makita EB5300TH Blower engine stops soon and the speed doesn't increase?
This issue may arise due to insufficient warm-up. Perform a warm-up operation to resolve this.
What to do if my Makita EB5300TH has another abnormality of spark plug?
Replace the spark plug.
How to operate the primer pump on my Makita EB5300TH?
Push the primer pump 7 to 10 times.
What to do if my Makita EB5300TH has an abnormal clearance of the spark plug?
Adjust the clearance of the spark plug.
What to do if my Makita EB5300TH has a lack of fuel?
Feed fuel.
What to do if my Makita EB5300TH has a choke lever set to “CLOSE” after warm-up?
Set the choke lever to “OPEN”.
General| Type | Cordless backpack blower |
|---|---|
| Power | 2500 W |
| Airflow | 900 m³/h |
| Airspeed | 352.8 km/h |
| Noise level | 96 dB |
| Suction mode | No |
| Product color | Black, Blue |
| Shoulder strap | Yes |
| Working technology | Four-stroke petrol |
| Power source | Gasoline |
| Vibration emission | 2.2 m/s² |
Weight and Dimensions| Depth | 450 mm |
|---|---|
| Width | 320 mm |
| Height | 475 mm |
| Weight | 9800 g |
