Makita ER400MP User Manual (English)

Other manuals for Makita ER400MP

Questions and Answers:

L
Larry PetersonJul 28, 2025
Why is the cutting attachment on my Makita Trimmer not rotating?
- L
  Leah MullenJul 28, 2025
  If the cutting attachment on your Makita Trimmer doesn't rotate, stop the engine right away. Here's what might be happening: * The cutting attachment might not be tightened securely. Make sure to tighten it properly. * There could be a twig or other foreign object caught between the cutting attachment and the protector. Remove any debris you find. * If neither of these fixes the issue, the drive system may not be working correctly. In this case, you should have it inspected and repaired by a Makita authorized service center.
J
Joanne HillAug 4, 2025
How to fix a Makita Trimmer when the nylon cutting cord does not feed?
- K
  Krystal WilliamsAug 4, 2025
  If the nylon cutting cord on your Makita Trimmer isn't feeding, it might be used up or tangled in the spool. Try rewinding the cord to resolve this issue.
A
Amanda GlassAug 12, 2025
Why is the nylon cutting cord on my Makita Trimmer not cut off at the correct length?
- J
  Jonathan JohnsonAug 12, 2025
  If the nylon cutting cord on your Makita Trimmer isn't being cut off at the correct length, it could be due to the following reasons: * The cord cutter on the protector might be damaged or missing. If this is the case, you should ask a Makita authorized service center to replace the cord cutter. * The cord might be extending past the protector. Try rewinding the cord.
T
Thomas GravesAug 19, 2025
What to do if my Makita Trimmer vibrates abnormally?
- K
  Kayla RodriguezAug 20, 2025
  If your Makita Trimmer is vibrating abnormally, stop using it immediately. This could be due to several reasons: * The cutting attachment might be broken, in which case you should replace it. * The cutting attachment might not be tightened securely; ensure it is properly tightened. * If you're using a nylon cutting cord, one end might be broken, causing the head to become unbalanced. Try feeding the nylon cutting cord by tapping the head on the ground. * If none of these steps resolve the issue, the drive system may not be working correctly. Contact an authorized Makita service center for inspection and repair.