P 6 / 6
Circuit diagram
Wiring diagram
Field
Noise suppressor**
*Resistor is not used for GA7020, GA7021, GA9020
**Noise suppressor is not used for some country.
Power supply cord
Switch
[1] Motor Housing
[2] Handle
Color index of lead wires' sheath
Black
Red
Resistor*
Rib
Switch
Lead wire holder
[to Switch]
Power supply cord
Route two Field lead wires (black) as illustrated below.
Route through the hook.
Fix with the lead wire holder.
Be sure that the wires
are tight in this area.
Put Noise suppressor
in this portion if used.
Fix the following lead wires with the lead wire holder:
*two Field lead wires (black)
*two lead wires (red) of Resistor (if used)
Put Resistor in this portion
(Resistor is not used for
GA7020, GA7021, GA9020)
Route the lead wires of Power supply
cord between the rib and Switch.
To Previous Page
Loading...
Need help?
General
