Need help?Do you have a question about the Makita HP332DZ and is the answer not in the manual?
General| Type | Hammer Drill |
|---|---|
| Voltage | 12V |
| Battery Type | Li-Ion |
| No Load Speed (Low) | 0-400 RPM |
| No Load Speed (High) | 0-1, 500 RPM |
| Max. drilling diameter in steel | 13 mm |
| Max. drilling diameter in masonry | 13 mm |
| Weight | 1.1 kg |
| Impacts per Minute (Hi) | 22, 500 IPM |
| Impacts per Minute (Lo) | 6, 000 IPM |
Maintain a clean, well-lit work area. Avoid hazardous atmospheres and keep bystanders clear.
Use correct plugs and outlets. Avoid contact with earthed surfaces. Protect from wet conditions. Do not abuse cords.
Use appropriate extension cords. Use RCD for damp locations. Stay alert, use PPE, prevent accidental starting. Do not overreach. Dress properly. Use dust collection.
Stay alert and use common sense. Do not operate when impaired. Wear protective equipment. Prevent unintentional starting. Maintain footing and balance. Dress appropriately.
Wear ear protection for impact drilling. Use auxiliary handles for control. Hold tool by insulated surfaces when near wiring.
Ensure firm footing. Hold tool firmly. Keep hands from rotating parts. Do not leave tool running. Avoid hot parts. Handle chemicals carefully. Use pliers for stuck bits.
Read all instructions. Do not disassemble. Stop if operating time shortens. Rinse eyes if electrolyte contacts them.
Do not touch terminals with conductive material. Avoid storing with metal objects. Do not expose to water or rain.
Follow local regulations for disposal. Use only specified batteries. Do not incinerate damaged batteries. Avoid dropping or striking.
To Next Page
